The particle packaging machine maintenance is probably as follows

The pellet packaging machine is generally used for packaging powdery granular materials with good fluidity. This machine is suitable for granular materials in various industries such as food industry, tea, medicine, chemical industry, daily chemical, hardware and so on. Any machine needs regular maintenance. The maintenance of the particle packaging machine is probably as follows, for reference:

Mechanical lubrication

1. The oil tank is equipped with the oil meter in the box body of the machine. All fuel should be filled once before driving. The temperature rise and operating conditions of each bearing can be added in the middle.

2. The worm gear box must store engine oil for a long time. Its oil level is worm gear all invaded into the oil. If it is used frequently, it must be replaced every three months. The bottom of the worm wheel has an oil plug and can be used for oil.

3. When the machine is refueling, do not let the oil spill out of the cup, not to flow around the machine and on the ground. Because the oil is easy to make the material pollution, affect product quality.

Care instructions

1. Regular inspection of mechanical parts shall be carried out once a month. Check whether the bolts, bearings and other active parts of the worm gears, worm gears, and bearings are rotated flexibly and in a worn condition. The defects shall be promptly repaired and shall not be used recklessly.

2. The machine should be used in a dry and clean room. It must not be used in places where the atmosphere contains acids and other gases that are corrosive to the body.

3. After the machine is used or when it is stopped, remove the rotating drum to clean and brush the remaining powder inside the bucket, and then install it to prepare for the next use.

4. When the roller is shaken before and after work, please adjust the M10 screw on the front bearing to the appropriate position. If the gear shaft is shaken, please adjust the M10 screw at the rear of the bearing frame to the proper position. Adjust the clearance so that the bearing will not make noises. Hand-turning the pulley. Suitable for tightness. Too tight or too loose can damage the machine. .

5, if the decommissioning time is longer, the machine must be wiped clean, the machine's smooth surface coated with anti-rust oil, covered with a cloth.

The machine needs maintenance and the operator should use the machine properly during the use and clean regularly.